LESSONS FROM MINI-PAINTING
As a player and and dungeon master of the famous TTRPG Dungeons and Dragons, I have gain some experience with miniature painting. The mini-painting hobby can be very deep and the real professionals blow my work out of the water! Nonetheless, I've become fairly proficient at painting 1 inch tall wizards, goblins, and fairies. I've always wondered where else the same techniques could be applied, like on architectural models. In this case, I found a lidar scan of the Louisiana State Capitol Building, 3D printed it, and gave it a shot!
Process and Technique
There are two main techniques I use. The more traditional method, which I used on this colored model involves just priming and painting like you would expect. After applying a flat base coat to everything, traditionally, you would then apply a darker wash (a much runnier paint) that fills in crevasse with darker pigment creating depth. After that dries you can "dry brush" lighter pigment onto the model to add even more depth. "Dry brushing" is a technique where a brush with very little paint is lightly dragged over raised surfaces to highlight only the most elevated portions of the model's texture.
The second method, which you can see in the monochrome model is called the "slap-chop" method. I am far more familiar with this technique and prefer it in general. This method involves priming the model black, doing a heavier gray dry brush pass, then a white dry brush pass for highlights, and finally painting on the color with special translucent paints. This technique essentially creates all the tone variations of light and shadow first, then washes the appropriate parts in color. This is also often much quicker. I found that stopping before adding color to an architectural model is a fairly solid way to render a print as it highlights details and shadows, while leaving some work, like exact colors, to the imagination. Its also cut out over half the labor.

Both methods however, I discovered, can cause issues in 3D printed models. Each use various techniques that rely on the texture of the model to build depth and color variation. On small injection-molded goblins, this works great as the only texture on the figure is that of chainmail, wood grain on shields, or the pattern of leather armor. However, when a 3D printed model shows layer lines, these arbitrary marks pick up those highlights in ways the flat surface they depict should not. The main portion of the building in this case is fine, but the subtle elevation change of the the flat roof and site create an abundantly visible stepped look. This could perhaps be mitigate with finer printing techniques or resin prints. Unfortunately I do not have access to those.... yet...
↑Back to Top